
The Fitlock solution designed to speed up panel installation: the female component fits into a dedicated groove and locks into place without screws.

Fitlock SuperColpo is designed to speed up the installation process on the panel.
Its exclusive patented design allows the female component to be secured without screws. The FLSC_F female component is inserted into a dedicated recess, created using the special PFSC35 double-diameter milling cutter, where it locks permanently into place.
If the panel does not have the special recess, the system can also be installed using 4 screws.

The FLSC female component is compatible with the entire FL series. The nominal disengagement force is determined by the paired male component.
The technical datasheet specifies a screwless configuration with a dedicated recess, or an alternative configuration using 4 screws when the panel does not have the special recess.
Installation dimensions vary depending on the selected configuration: 6 mm Gap, 3 mm Gap or No Gap. Refer to the dimensional drawing and installation diagram before machining the panel.
| General specifications | |
|---|---|
| Item | FLSC |
| Component code | FLSC_F |
| Material | Polycarbonate |
| Type | Female |
| Recess diameter | Ø 40 mm |
| Total weight | 5 g |
| Nominal disengagement force | Refer to the specifications of the paired male component |
| Compatibility | Entire FL series |


Fitlock SuperColpo is a press-fit fastening system featuring a special female component designed to snap into the panel. The system speeds up installation and reduces the need for screws.
Yes. The FLSC female component is compatible with the entire FL series. The nominal disengagement force depends on the paired male component.
The female component is inserted into a special double-diameter recess, created using the dedicated PFSC35 milling cutter. Once inserted, it locks permanently into place inside the panel.
Yes. If the panel does not have the special recess, the female component can be secured with four screws. The special Fitlock VFL12 screw or a 3.5 mm countersunk screw can be used.
Snap-in installation is suitable for panels with mechanical properties that ensure secure retention of the female component. Screwless installation is not recommended on fragile substrates. The choice of installation method must take into account the characteristics of the panels.
For screwless installation, the special PFSC35 milling cutter is required to create the double-diameter recess. The M marker is also available to accurately identify the installation points. VFL12 screws are available for the alternative fastening method.
The system allows multidirectional adjustment of up to 4 mm in all directions, facilitating panel alignment and positioning during installation.
Fitlock SuperColpo offers three configurations: No Gap, 3 mm Gap and 6 mm Gap. These allow the distance between the panel and the substrate to be adjusted to meet project requirements.