
A stainless steel system designed for applications requiring non-combustible materials, a minimal gap between panel and substrate, and the possibility of using thin panels.

This configuration integrates the washer directly into the female component, which is recessed into the panel. The solution protects the system during handling and transport, keeping the fastening element protected and recessed within the panel.
The system consists of two components: the female component installed in the panel and the male component fixed to the substrate. The connection is made by applying pressure.

The system configuration allows 3 mm of adjustment in all directions, facilitating correct positioning and alignment of the panels.

Fitlock Inox is designed for installing ceiling and wall panels in environments where non-combustible materials are required.
Thanks to its thin flanges and low-profile fastening system, Fitlock Inox minimizes the distance between the panel and the substrate.
It is suitable for thin panels, with a minimum thickness of 9 mm.

The system is available in Soft and Hard versions, featuring two male component configurations to adapt the retention force to different application requirements.
Normal force required for disengagement: 120 N ±10%
Normal force required for disengagement: 120 N ±10%
The technical datasheet illustrates the 2 mm Gap and No Gap configurations, along with their respective installation cross-sections.
Install the female component in the prepared recess in the panel, ensuring correct positioning and alignment. Install the male component on the substrate using the designated fixing points. Bring the panel towards the substrate and engage the system by applying pressure.
The technical datasheet specifies that the fixing holes of the male and female components must be offset by 60° to prevent the screws from overlapping.

The following data is taken from technical datasheet FLI01-2060929-IT.
| General specifications | |
|---|---|
| Item | FLI2 |
| Material | STAINLESS STEEL/GALVANIZED STEEL |
| Adjustment | 3 mm in all directions |
| Recess diameter | Ø 29 mm |
| Flat dimensions | Ø 54 mm |
| Total weight | 20 g |
| Screws to use | Flat countersunk head Ø 2.5 mm |
| Minimum panel thickness | 9 mm |

| Component | Soft | Hard |
|---|---|---|
| Male | FLI2_M | FLI2_MH |
| Female | FLI2_F | FLI2_F |
| Complete assembly | FLI2S | FLI2H |
| Normal force required for disengagement | 120 N ±10% | 120 N ±10% |

It is a stainless steel press-fit fastening system designed for installing ceiling and wall panels.
It is designed for environments where non-combustible materials are required. The technical datasheet also specifies a reduced gap between the panel and the substrate and suitability for thin panels.
Fitlock Inox is suitable for thin panels, with a minimum thickness of 9 mm.
The system allows 3 mm of adjustment in all directions.
The system is available in Soft and Hard versions, featuring two different male component configurations.
The technical datasheet illustrates two configurations: 2 mm Gap and No Gap.
The fixing holes of the male and female components must be offset by 60° to prevent the screws from overlapping.